This is TikiWiki 1.9.7 -Sirius- © 2002–2006 by the Tiki community Fri 28 of Jul, 2017 [18:57 UTC]

Forum: Hot Heads Tech Talk

Forums->Hot Heads Tech Talk->Spacer Ind 56

moparlarry
Spacer Ind 56


I have one of the industrial 354s that requires a spacer in the intake gasket to line up the bolt holes in the intake. Does anyone know the thickness of that spacer plate ? question thanks for looking.
  user offline
on: Fri 23 of Dec, 2016 [02:59 UTC] reads: 2282

Posted messages

Top
author message
George
user offline
Re: Spacer Ind 56
on: Fri 23 of Dec, 2016 [22:55 UTC] score: 0.00
All intakes interchange when new. Probably either the intake, heads, or both have been milled at some point. Get bolts long enough to screw in & measure the gap.


Page: 1/1

Show posts: