This is TikiWiki 1.9.7 -Sirius- © 2002–2006 by the Tiki community Fri 16 of Nov, 2018 [09:16 UTC]

Forum: Hot Heads Tech Talk

Forums->Hot Heads Tech Talk->1957 poly enging

Wcboy
1957 poly enging


Hi I just picked up a wc10 project and its original t207 was replaced with a 1957 325 poly , kds is stamped on the top
I believe this can be converted to a full hemi by changing the heads?
Is there any value to this engine?
Missing carb been sitting outside for years
If it's worth messing with I can open it up.
Thanks for any information

  user offline
on: Thu 12 of Oct, 2017 [03:09 UTC] reads: 5272

Posted messages

Top
author message
George
user offline
Re: 1957 poly enging
on: Thu 12 of Oct, 2017 [12:01 UTC] score: 0.00
Yes, you'll need the complete head assemblies including push rods & ex mans, plus pistons. Value depends on condition, especially sitting outside.

author message
Wcboy
user offline
Re: 1957 poly enging
on: Thu 12 of Oct, 2017 [03:10 UTC] score: 0.00
> Hi I just picked up a wc10 project and its original t207 was replaced with a 1957 325 poly by the casting numbers, kds is stamped on the top
> I believe this can be converted to a full hemi by changing the heads?
> Is there any value to this engine?
> Missing carb been sitting outside for years
> If it's worth messing with I can open it up.
> Thanks for any information
>


Page: 1/1

Show posts: