This is TikiWiki 1.9.7 -Sirius- © 2002–2006 by the Tiki community Mon 09 of Dec, 2019 [07:04 UTC]

Forum: Hot Heads Tech Talk

Forums->Hot Heads Tech Talk->Re: Intake Plumbing

Webmaster
Re: Intake Plumbing


Wfrager:
if you have a need for more water access, your machine shop can drill and reverse tap them. No restrictors are required and all water holes in the remote therm and HH intake are 1/2" pipe. You can drill the remote therm. or the intake for water access. Hope this helps, Bob






> Got my new HH dual plane intake, looks great. It has only two water outlets, where as my previous intake had 4, front and back. There were restrictors in the outlets. Should I be concerned 2 vs. 4 water outlets? Should I use restrictors? Will -8AN hose suffice to the remote T-stat?
>
> Lastly, my remote tstat housing has my gage sender in the base, but I need to install another temp sensor for the EFI computer. Could I drill and tap the intake?
  user offline
on: Wed 08 of Feb, 2017 [13:54 UTC] reads: 679

Posted messages

Top

Page: 1/0

Show posts: