This is TikiWiki 1.9.7 -Sirius- © 2002–2006 by the Tiki community Wed 18 of Jul, 2018 [08:44 UTC]

Forum: Hot Heads Tech Talk

Forums->Hot Heads Tech Talk->Re: Pulling spark plug tubes

Jack
Re: Pulling spark plug tubes


> Have a set of tall block DeSoto heads that I’m getting ready to rebuild. Someone managed to get the valve covers off without getting all of the plug tubes out. Plugs have all been removed. Three tubes seem stuck pretty tight. Anyone else encountered this before? I’m considering getting a piece of H R steel 1.25” diameter (I.D. Of the tube), drilling it through end to end and threading it to match my slide hammer. Figure if I stuck it into the tube and clamped Vice-Grip onto it, I might be able to pull them. Is there a simpler approach?
  user offline
on: Thu 10 of May, 2018 [18:01 UTC] reads: 42

Posted messages

Top

Page: 1/0

Show posts: