This is TikiWiki 1.9.7 -Sirius- © 2002–2006 by the Tiki community Sun 18 of Aug, 2019 [19:14 UTC]

Forum: Hot Heads Tech Talk

Forums->Hot Heads Tech Talk->Re: temp sender location

Webmaster
Re: temp sender location


Never:
On the Hot Heads intakes, there is a 1/2" NPT threaded boss between the first and second port on each side that go to water. A cleaner way is to use the Hot Heads water blocks #21603. Most folks use the passenger side for the heater hose, (concealed) and the drivers side for the temp sender, again concealed.
I hope this helps,
Bob





> My '55 331" motor from a New Yorker is the subject.
> I have installed a 6-71 blower manifold, a HH crossover assembly and an aluminum BBC water pump.
>
> What is not obvious is where do I put a coolant temp sender.
> Will I need to build a "loop" between the heater ports in the water pump to create a port for the sender?
  user offline
on: Fri 03 of May, 2019 [16:37 UTC] reads: 126

Posted messages

Top

Page: 1/0

Show posts: