This is TikiWiki 1.9.7 -Sirius- © 2002–2006 by the Tiki community Fri 18 of Sep, 2020 [14:34 UTC]

Forum: Hot Heads Tech Talk

Forums->Hot Heads Tech Talk->Re: 331 cam/compression question

George
Re: 331 cam/compression question


Probably should talk to Bob on the cam. milling block/heads affects the valve train geometry. I wouldn't do it unless necessary. While expensive changing C/R with different pistons is the way to go. It should be noted that advertised C/R has been found to be optimistic on measured engines.
  user offline
on: Thu 25 of Jul, 2019 [13:33 UTC] reads: 414

Posted messages

Top

Page: 1/0

Show posts: