This is TikiWiki 1.9.7 -Sirius- © 2002–2006 by the Tiki community Sat 19 of Sep, 2020 [11:54 UTC]

Forum: Hot Heads Tech Talk

Forums->Hot Heads Tech Talk->Tall Deck Dodge

Tall Deck Dodge

Does anyone make the adapter plates to install a low deck 241/270 hemi 4 barrel aluminum intake on a tall deck 315/325 hemi? I have made some in the past and it was a real job. I also have taken other after market intakes for non Mopar engines and did a lot of cutting, heli-arcing and grinding to get there. If no one know of any, I guess I'll go back to making some again. Thanks for any leads.
  user offline
on: Mon 23 of Dec, 2019 [22:12 UTC] reads: 4336

Posted messages

author message
user offline
Re: Tall Deck Dodge
on: Fri 03 of Jan, 2020 [00:20 UTC] score: 0.00
I think it is sad, when I ask a legitimate question and get dumb replies. Before I asked about using Spectra Chrome paint on my one intake. I got a bunch of people calling me cheap, etc. They said get it chromed, but I wanted the gold plated look. Real gold was super outrages. Well I went ahead and had it done with Spectra Chrome Gold. It looks great and holding up well to the engine heat.

Now for the manifold, I don't know of anyone selling aluminum tall deck 4 barrel intakes. I thought if someone was selling them, then someone would point me in the direction. I have a couple aluminum low deck units and I also have a couple tall deck cast iron 4 barrel units.

So mine was a real legitimate inquiry, not bragging. So does anyone know of anyone making tall deck aluminum 4 barrel manifolds for the 325 Dodge or spacers to mate the low deck manifold to the tall deck engine?

Thanks for any real help!

Page: 1/3  [next]

Show posts: