This is TikiWiki 1.9.7 -Sirius- © 2002–2006 by the Tiki community Thu 06 of May, 2021 [12:27 UTC]

Forum: Hot Heads Tech Talk

Forums->Hot Heads Tech Talk->Re: Re: Re: Re: Breather setup?

392PT50
Re: Re: Re: Re: Breather setup?


>
> > No, this is a street/strip truck. I'll see if I can come up with something like you suggest. I was thinking about a remote catch can/breather setup.
>
> To breath properly you need a way to get fresh air in & suck out the old. The OEM set up the fill cap has a breather to let air in, Then replace the puke tube (draft tube) with a PCV set up. I'm sure your billet one looks better, but.....

I think I'll plumb a barb in the front of the VP and run an inline PCV to the front port on the carb. then I'll plumb a fitting into the rear of the pan and run that to a remote breather. Think that would work?
  user offline
on: Tue 09 of Mar, 2021 [19:40 UTC] reads: 46

Posted messages

Top

Page: 1/0

Show posts: